人寡聚蛋白(oligomeric)ELISA試劑盒標本要求：

1．標本采集后盡早進行提取，提取按相關文獻進行，提取后應盡快進行實驗。若不能 馬上進行試驗，可將標本放于-20℃保存，但應避免反復凍融 

2．不能檢測含 NaN3 的樣品，因 NaN3 抑制辣根過氧化物酶的（HRP）活性。 

3．組織處理：切割標本后，稱取重量。加入一定量的 PBS，PH7.4。用液氮迅速冷凍 保存?zhèn)溆谩?biāo)本融化后仍然保持 2-8℃的溫度。加入一定量的 PBS（PH7.4），用手 工或勻漿器將標本勻漿充分。離心 20 分鐘左右（轉/分）。仔細收集上清。 分裝后一份待檢測，其余冷凍備用。

人寡聚蛋白(oligomeric)ELISA試劑盒常見問題解答：?jiǎn)枺何铱梢允褂迷噭┖姓f(shuō)明書中不推薦的樣本類型嗎？答：我司試劑盒已針對試劑盒說明書中列出的樣本類型進行了驗證。除已驗證的樣本類型外，其他樣本類型尚未進行測試。有關更多信息可聯系我司技術服務部門為您解答。Q:Can I use a sample type that is not recommended in the kit insert?A:The kit has been validated for the sample types listed in the kit insert. Sample types other than those validated have not been tested. Contact Technical Service for further information.問：我的樣本生成的值超出了分析的動態范圍，我能用這些樣本值么？答：建議僅使用標準曲線范圍內的樣本值。標準曲線范圍之外的值通常是非線性的，這可能會導致錯誤的外推值。產生高于zui高標準值的樣品應（）稀釋并重復測定。如果樣品低于測定范圍，則認為樣品不可檢測。Q:My samples generated values that were outside the dynamic range of the assay. Can I use these values?A:It is recommended that only sample values that fall within the range of the standard curve be used. Values outside the range of the standard curve are generally non-linear, which can lead to incorrectly extrapolated values. Samples that generate values higher than the highest standard should be (further) diluted and the assay repeated. If samples fall below the range of the assay, the sample is considered to be non-detectable.